Temporary Hours: Mon. - Thurs. - 9am -5pm - Fri. 9am-1pm - Please Inquire For Special Arrangements
Enforced Social Distancing - Masks - Carefully Sanitized Equipment & Facilities
The Pincher is a universal HDMI cable restraint for DSLR's. It is the perfect solution for keeping your HDMI cable in place. It includes the pincher device and a mounting bar that will allow you to use it out of the box on the Zacuto Gorilla Plate or DSLR Baseplate. The mounting bar attaches to the Gorilla Plate or DSLR Baseplate by using the two allen screws that also attach the red thumb screw slider block to the baseplates (if you are familiar with mounting the Z-Finder Frame on the Gorilla Plate or DSLR Baseplate, the mounting bar is attached the same way).
The Pincher has horizonal adjustment as well as vertical adjustment so you can line the Pincher up to work on multiple DSLR cameras. To adjust horizontally or vertically, loosen the red thumb screws positioned at the bottom and/or side of the Pincher and slide; once positioned, tighten the red thumb screws.
The Pincher has many configurations to work with multiple cameras. It has been tested on the following cameras: Canon T2i, Canon 60D, Canon 5D, Canon 7D, Canon 1D, Lumix GH2, Nikon D3100, Nikon D7000 and Nikon D3s. It also works when using battery grips with the Canon 5D,7D and T2i. The Pincher will need to be configured differently depending on your camera. Please refer to the instruction sheet found Here