Please Note: This Week We Are Open Only At Our Brooklyn Location
The GLIDECAM SMOOTH SHOOTER is the World's most sophisticated and affordable body mounted Camera Stabilization System designed for Cameras weighing up to 6 pounds when used with the Glidecam 2000 Pro, or for Cameras weighing from 4 to 10 pounds when used with the Glidecam 4000 Pro. The GLIDECAM SMOOTH SHOOTER system will allow you to walk, run, go up and down stairs, shoot from moving vehicles and travel over uneven terrain without any camera instability or shake.
The SMOOTH SHOOTER system works by isolating your body's motion from your camera, while your camera is balanced in a relatively motionless and isolated state. The SMOOTH SHOOTER'S Support Arm can be boomed up and down, as well as pivoted in and out, and side-to-side. It is the combined booming and pivoting action of the Support Arm, which isolates your motions from the camera in a way that creates smooth camera footage.
Specifically designed to be used with the Glidecam 2000 Pro, or 4000 by simply attaching it to the end of the Smooth Shooter's Support Arm. You can use your camcorder's flip out LCD monitor, or a monitor that is attached to the base of your Glidecam 2000 Pro or 4000 Pro. This allows for remote viewing of the camera's image without disturbing the orientation of the system.
When using the Glidecam 2000 Pro or Glidecam 4000 Pro in hand-held mode, it is your arm that carries all of the weight. However, when the 2000 Pro or 4000 Pro are used with the SMOOTH SHOOTER, it is the SMOOTH SHOOTER'S Spring-loaded Support Arm that carries all of the weight. Because of this, you will now be able to shoot for extended periods of time, whereas before, the stress associated with hand-holding the weight reduced your shooting time.
The Smooth Shooter's Dyna-Elastic™ Support Arm incorporates more than twenty precision radial bearings within its machined T6 aluminum structure. The placement and implementation of these double-shielded bearings produce minimal friction and allow the Dyna-Elastic™ Support Arm to pivot and boom very smoothly, and with virtually no noise.
Two high-carbon alloy, Extension Springs are employed within the Support Arm's hardcoat anodized Exo-Skeletal Shell. Utilizing Class Three Levers, the energy of the Extension Springs acts upon internal Fulcrum Points, and provides the Support Arm with its lifting power. The spring tension is field adjustable and allows for varying camera weights.
The proprietary spring Inter-X-Change™ system makes the installation and removal of the springs quick and easy. The Support Arm can be setup and used in either a One-Spring Mode, or a Two-Spring Mode. In the One-Spring Mode, the Support Arm can hold a total combined camera and hand-held stabilizer weight of 9 pounds. In the Two-Spring Mode, the Support Arm can hold a total combined camera and hand-held stabilizer weight of 18 pounds.
A key design feature of the Support Arm is that it incorporates our Light-Force™ technology. This literally means that only a "light" force or effort is required by the operator to hold the arm at any given position, or to boom the arm up and down. It is this Light-Force™ feature that provides the operator with the optimum amount of camera buoyancy or float.